Posts

Sort multiple columns

Have you ever been sorting columns over and over in reverse order to in the end get the grid sorted by multiple columns? Occasionally one has a sorting and want to freeze the current sorting and apply a second subsorting. 

Hold down Shift and click on the additional columns you want to sort, and they will be sorted in order from most significant, second, third and so on. 

Objects ordered by Byggnadsplacering, Processfunktion

Ctrl + Shift + K 

This command can be used in grids and will perform the following actions. All fields/columns without any data are hidden. The width of shown fields is set to best fit, adjusted according to the widest data. 

Example scenario: Empty cells marked with pink. Unless we were inspecting of those specific fields were empty or not the view give us little information. Are all fields to the right empty? Are all rows below empty? 

Notice the size of the scroll bar. It is representative of how much data is shown out of the data loaded to the grid. When using the shortcut Ctrl+Shift+K the grid focuses on the non-empty cells. 

Fill upp

Hold Ctrl to access Fill up 

By holding Ctrl as modifier when opening the right click menu Fill down is replaced by Fill up. 

Could come in handy when filling large amounts of ordered data and want to use a fill series without having to scroll to the top between each filling.  

Set which AutoCAD to run elMaster Design

When starting elMaster Design the application start will first start the AutoCAD you used last and then load elMaster Design functionality. If there are more AutoCAD products installed you need to make sure the desired product is the one you had last started before starting elMaster Design. Assuming you always want the same version and product there are settings to make switching applications easier.

Settings for MasterConcept

The configuration of what application to start is found among the document settings; Administration > Settings > Document > Document type. Go to the tab Document Start and look for the columns External Application and Switches.

External Application & Switches

Currently using AutoCAD 2015 while trying out 2016.

The column Switches works very much the same way as adding switches to a program shortcut. The following switches are supported both as shortcut and document start setting.

/product is passed on to AutoCAD and accepts the same input as the native AutoCAD switch. It expects a product shortname like; ACAD, ACADM, MEP

/acadver accepts version as written in the name of the vertical; 2014, 2015, 2016. Version numbers on format R19.1 are currently not supported. Please note that support for this switch was intruduced in 12.2.2.

/p is the native AutoCAD switch for profile. For some starts you may have to refer to an existing profile to get the desired environment. If no profile is specified AutoCAD will be launched and AutoCAD will continue using which ever profile is current.

When setting external application to MasterDesign the Design profile is loaded by the document start and there is no need to specify profile.

 

Settings for stand alone elMaster Design

The switches above are supported by stand alone elMaster Design by editing the shortcut adding the desired switches.

Shortcut with switches

Shortcut with switches

 

Depricated

Edited. The tags described below are depricated from 12.3 and the above alternatives are  recommended. Tags are only to be used for older AutoCAD versions before acad.exe had support for the product switch.

As an alternative the settings are also available through the settings file.
%appdata%\Ides\Master Concept 12\Cfg\IdesSettings.xml

IdesSettings.xml

Tags in IdesSettings.xml

To set a preferred version of AutoCAD add the tag SelectedAutoCADVersion and a version number such as; 2014, 2015, 2016.

To set a preferred AutoCAD-product add the tag ElmasterAutoCADProduct and a product shortname like; ACAD, ACADM, MEP.